Easy-to-use 2-ton Heavy-duty Jack, Hydraulic Low-profile Car Service Jack, Includes Storage Bag

Air Venting Procedures• Use only on hard, level surface capable of supporting the load.• Center load on saddle prior to lifting.• Support the vehicle with appropriate means immediately after lifting.• Do not move or dolly the vehicle while on the jack.• Lift only on areas of the vehicle as specified by the vehicle manufacturer.

With the jack in the fully lowered position, release valve open, remove oil filler plug.• Pump the handle rapidly several times. Reinstall oil filler plug.• Turn the handle/release valve clockwise to the closed position.• Pump the handle until the lift arm reaches maximum height and continue to pumpseveral times to remove trapped air in the system.

• Turn the handle/release valve counterclockwise in one full turn and lower lift arm to thelowest position. Use force on saddle if necessary.• Carefully and slowly loosen oil filler plug to release pressurized air.• Repeat above steps until trapped air is completely vented.

Assembly• If two piece handles are provided, assemble the upper section into the lower section, line up the holes, insert and tighten • Insert the bottom end of handle into handle fork and securely tighten the bolt and washer. Ensure the handle can turn freely.

Lifting• Turn the handle/release valve clockwise to the closed position. Do not over tighten.• Position the jack under the specified lift point.• Begin lifting by pumping the handle up and down.• Immediately after lifting, support the vehicle with appropriately rated jack stands.• Turn the handle/release valve slowly counterclockwise to lower the vehicle onto jackstands.

LoweringTurn the handle/release valve clockwise to the closed position. Do not over tighten.• Pump the handle up and down to lift vehicle off jack stands.• Remove the jack stands. Do not get under or let anyone get under the vehicle whilelowering.• Turn the handle/release valve slowly counterclockwise to lower the vehicle onto theground.